A while a go, I had bought a $20 MIDI controller which I was going to transform into a wireless controller. Recently I need a smaller and more portable controller then the Traktor S4. As expected as I took it apart, it was lots of smaller PCBs in a case and not one big PCB. They made it easier to customise it. The Central board had everything I need; all controls, processor and USB interface. The board had everything but was the wrong shape, there were two extra parts coming out from either side of the board which need to be cut off. Some tracks were on the part then need to be cut off which meant I need to solder new tracks to the board. After the board had been modified, it was time to design the new case to house the board. The case design was similar to the original case but a lot smaller. This project did not take long to complete, only a few hours.
This is a version of the torch module is a module that can be placed anywhere. The module does …
This is a version of the torch module to test the shape and the power of the LED. This module …
3D printed Sandblaster
This is a sandblasting gun for sandblasting and somehow this works and does not destroy itself …
Stand, Clamps and Equipment Kit
This has so many different uses not only in chemistry. This kit can be used in engineering, …
Novation Launchpad Mini Repair
do you have a Launchpad?
I get a lot of questions about this repair and if I would walk …
Traktor S4 Controller Repair
I have always wanted to have a look at the inside of the S4 controller to see what it is like. …